LXT-340A SPECIFICATIONS ------------------------------------------------------------------------------- Steps for formattong the LXT340A ------------------------------------------------------------------------------- Run setup: The CMOS SETUP tables need to be checked to see that a hard drive entry is included. With a "REAL" IBM (R) PC AT (R) use the IBM (R) diagnostic diskette ot change the CMOS SETUP. With a compatable it may be possible to access and change the SETUP information by by using keyboard code (eg CTRL-ALT-ESC) The information on what to use should be in the system manual THE LXT340A HAS THE FOLLOWING CHARACTERISTICS: 654 CYLINDERS 16 HEADS 63 SECTORS IF THIS CONFIGURATION IS NOT AVAILIABLE IN THE SYSTEMS BIOS, USE THE CONFIGURATION THAT IS THE CLOSEST MATCH. DO NOT GO EXCEED ON ANY OF THE PARAMETERS. PARTITIONING: Use the F-DISK software to partition the drive. FORMAT: After partitioning the drive you need to perform the high level format. (eg. FORMAT C:/S) NOTE: "DO NOT LOW-LEVEL FORMAT THIS DRIVE!!!!" This has already been done at the factory.