7120A INSTALLATION GUIDE


1.) Install the drive with the stripe on the 40 pin cable facing the 
power connector. Use the user definable BIOS type to set up the 
drive with 1024 Cyls., 14 Hds., and 17 Sectors. No pre-comp and 
no Landing Zone. This will format to 124,7 MBytes.

NOTE: If a user definable drive type is not available the other 
acceptable parameters are 900 Cyls., 15 Hds., and 17 sectors.
This drive type will only format to 117,5 MBytes.

2.) Boot the computer with your DOS boot disk. (at least 3.3 or higher)

3.) Go into the "FDISK" program and set the partitions as required for your
application.

4.) High-Level Format your partitions i.e. "FORMAT C:/S". Repeat
this for each of the partitions created.

5.) The 7120A is now ready for use. This drive does not require nor do
we recomend a Low-Level Format.