QUICK INSTALLATION GUIDE<<
                         IDE/AT<<

Conner drives are low level formatted at the factory. It is only<<
necessary to run SETUP, FDISK and DOS FORMAT.<<

Model     Hds  Cyls  Sec    Pcomp  L-Zone    Type    Table  LED<<
CP30084E  4    903   46       0    903       *UT       3    C<<

Table 3 jumper settings:<<
     Single and Master drive = Jumper C/D<<
     Slave drive = no jumper<<

*UT = Universal translate. Select a drive type that is close to,<<
but does not exceed the megabyte capacity of the drive. The drive<<
will translate to the megabyte capacity you have selected.<<

 LED<<
C: J-5<<
Pin 3 = +<<
Pin 4 = -<<

ST-1102A and ST1102A-32<<

     ===PWA=====================================================<<
                          +....................+    /---------\<<
                           ...................1     | O O O O |<<
       1 o o 2  --------\       \ Cable Connector   +-5-G-G-12+<<
       3 o o 4  ------\ |<<
       5 o o 6  ----\ | |<<
       7 o o 8  --\ | | |<<
       9 o o 10 \ | | | |                               1=closed 0=open<<
                | | | | \-- Life-Test (Factory use)<<
                | | | \---- Master on (Slave off) ----  1  1  0<<
                | | \------ Slave Present ------------  0  1  0<<
                | \-------- Reserved<<
                \---------- Remote LED                  S  M  S<<
                                                        i  a  l<<
                                                        n  s  a<<
                                                        g  t  v<<
                                                        l  e  e<<
                                                        e  r<<

Translation to use: 1024 cyl, 10 heads, 17 sectors = 89,128,960<<