BIOS 1.00.06.BU0 Advanced/MA Release 6.0

Features/Errata Fixed In This Release:

o Fixed the problem in which the date couldn't be set to February 29,2000 
  in the Setup.
o Changed the code to prevent incorrect operation of IRQs selected/deselected.
  Proper Operation: No more than one IRQ should be "not effective" 
  (grayed and unselectable) at any one time and this IRQ must be set to 
  "available". If upon entering this screen, no IRQ is set to available, 
  one IRQ will change from "Used by ISA" to "Available" and made not 
  effective. IRQ 12 is an exception. IRQ 12 can never be the only IRQ set
  to "Available".
o Corrected error where last byte of logo block was overwritten with a zero
  whenever the jumper to clear CMOS (and ESCD) was set and ESCD had invalid
  header offset length.  Problem Symptom: Boot board with newly programmed
  flash part and the jumper set to clear CMOS (and ESCD).  An FMUP verify
  operation will fail.
o Fixed problem of fields being accessible when Admin password restrictions
  were in effect.
o Added Scan User Flash related translations.
o Added code to check for valid day. Added code to set time to 00:00:00 on
  date/time error.
o Fixed problem that reported invalid device node data when no mouse 
  installed.
o Changed POST string "CD-ROM Drive" to "ATAPI Device."
o Stopped using the battery bit in the RTC as an indication of CMOS validity.
  This bit in the National 306 had been unreliable.
o Added Scan User Flash Area option in Boot Option menu.
o Added the latest Crystal Plug and Play CS4232 Audio BIOS.
o Added CD-ROM as first boot device option only.
o Added latest ATA/ATAPI drive detection code.        
o Freed IRQ15 when the Secondary PCI IDE channel is disabled via Setup.
o Token ring remote boot fix.
o CMOS corruption fix.
o 306B com port programming fix.
o Gate A20 race condition fix.
o CPU Autohalt fix.
o APM serial port mouse detection.
o Fixed the problem when a security password was set and a system was in a power
  saving mode, a serial mouse could wake the system up bypassing the password.
o Support BIOS recovery via Misty card.
